Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Steps made of 32 mm hardwood.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Steps made of 32 mm hardwood.

Appliance made of non-impregnated mountain larch, sawn timber heart-cut. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Steps made of 32 mm hardwood. High-quality roller bearings made of chrome steel or stainless steel for rotating elements, low-maintenance, easy to replace, sealed. Handcrafted water wheel construction with grooved and slotted wooden connections Shaft, hub and wheel tyres made of V2A, glass bead blasted. Closed design piston suction pump. Built into the column is the valve combination for direct connection to a pressurised water pipe, a shut-off valve with backflow preventer type EA and drain. Drinking water up to the lower edge of the pump base.
Water outlet height: 92 cm
Pumping capacity: approx. 0.3 l/revolution
Connection pipe: 1 inch
Water requirement: approx. 18 l/min
Water pressure: min. 2.5 bar, max. 6 bar
Water outlet: no drinking water

Unit made of non-impregnated mountain larch, sawn timber heart-cut. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Richter-Herkul rope, Ø > 20 mm, made of galvanised six-strand steel ropes, wrapped and bonded with polyester yarn, with very good abrasion resistance, firm hold of the sheathing even in the event of punctual damage. S-connector, Ø 8.1 mm, made of high-quality stainless steel, rounded.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Richter-Herkul rope, Ø > 20 mm, made of galvanized six-strand steel ropes, wrapped and bonded with polyester yarn, with very good abrasion resistance, firm hold of the sheathing even in the event of punctual damage. Fixed rope connection. Profiled pulley for optimum pressure distribution and protection against water ingress. Retractable two-part screws. Slide bar made of V2A glass bead blasted.

Unit made of non-impregnated mountain larch, sawn timber heart-separated. Rinds (4-5 cm) white-peeled by hand, natural tree surface remains tangible and tactile. Tongue and groove planks made of 4 cm solid wood, highly resilient, no trickling through. Steps made of 32 mm hardwood.